Search This Blog

Monday, November 6, 2017

Mahogany Curved Blockfront Chest Mounting Pulls & Locks Step 8

Time to mount the hardware before I start finishing.  I ordered the back plates, pulls and escutcheons from Ball & Ball.

Since the drawer fronts are curved the back plates have to be bent to fit the drawer fronts.  I just did this in the last project for the curved blockfront lowboy.

I have a block with a radius smaller than that of the drawer front.  I use a strap clamp to bend it on the block and hold it in place.


 Then I bang it a couple of times with a dead blow hammer to help make it conform to the curve of the block.


The brass springs back and just fits the front curve.  This is a sample curved front I had been using to test the finishing color.


Then I need to bend the bail, I do it the same way with the strap clamp and dead blow hammer.


The holes have to be drilled at an angle, we will get to that in a minute.  But this is how it is suppose to look when mounted correctly.  I chose to mount the hardware in the middle of each drawer.


To drill the holes at the correct angle, I drilled a practise piece and measured the angle with a sliding bevel, then I set my drill press table to that angle. About 10 degrees. I marked where I wanted the holes from the back plate and then drilled them.


Turned the drawer around and drilled the other hole.


Here we have all of the pulls bent and mounted.  The next step is to mount the locks.


The locks I ordered from Horton Brasses.  They have a lock pin at 1 1/8 inch from the top of the lock.  So the escutcheons have to be set 1 1/8 inches from the top to the round part of the key hole. It fits on the smallest drawer.


I use the lock as a template to draw the outline for the deep and outer mortise of the lock.  The pin is offset in the lock, so you have to be careful to set the pin in the middle of the drawer, not the lock body.


I use the lock as a template to mark the mortise that I need on the top as well.


I used a saw to cut the lines for the deep lock mortise.  That is how the old guys did it in the 18th century.  You can't see it very well here, so watch the video for more detail.


Using my dovetail chisel here to chop out the mortise here after sawing the sides of the mortise.
When I get close to the bottom of the mortise, I'll use the router plane to make a nice flat bottom.


Routing the bottom of the mortise flat.


Working on the shallow mortise for the back plate and the top mortise for the lock.


If I did everything correct the lock should fit right in after I drill the hole for lock pin.  Hope it is in the right place.



I traced the key hole on the front from the escutcheon plate and cut it out with a keyhole saw.  Then I used small rasps and files to clean it up.


Fitting the lock into the opening, so far it seems to fit.

\
Testing to see that the key fits and the lock works.


I match the escutcheon to the hole to check the fit.  Looks good at this point.  Only three more to do.


That's it for is post.  The next will be the finishing post.

Here is today's video: 

No comments:

Post a Comment